Furnace and Wing Stand

After a shakedown period, I finally got my Dad's old furnace on-line. Sure nice to work in a non oxygen-depleted atmosphere at humidity levels below 100%. Here is final install pic:

I was ready to mount the fuselage on the rotisserie stand, however, I needed to do something with the wings. Therefore, I devised the following wing stand to stage wings, both now and after covering and painting. I also wanted something that I could use to transport completed wings to the airport where they will be attached eventually. It was dimensioned off of a 4x8 sheet of 3/4" plywood with height set to accomodate 50" wing. It has heavy duty castering wheels. Should hold all of the smaller covered pieces between wings. Next step is to mount wings and get the fuse on the stand for covering.